From k8xxx-3dprinter
Jump to: navigation, search

THIS PAGE AND IT'S FOLLOWUPS ARE CURRENTLY BEING MANUALLY TRANSLATED FROM GERMAN
Check back later for the completed translation.
The original (german) source of the Article is found here


Introduction

On Thingiverse i found a manual how to modify the printer to an H-Bot : http://www.thingiverse.com/thing:490058 Because an H-Bot nearly is a CoreXY already, i decided to take that manual as a foundation. The advantages of a CoreXY over a H-Bot are described here.

Because i just started the modification and still wait for parts, this article is still under construction.

Parts

The following parts need to be printed:



The following parts need to be gathered (!!!still under reserve!!!)

  • 1x GT2 belt >3m (exact length follows)
  • 2x GT2 Pulley 16 tooth for stepper (if not already there)
  • 8x ball bearing 625ZZ 5x16x5 (2 are needed per roll)
  • 8x ball bearing 605ZZ 5x12x5 (2 are needed per roll)



Construction

The most sensible intervetion in the contruction of the K8200 is the removal of the front and back frame truss. This is necessary to make room for the belts, that run in the space between truss and sled on the front and back side. The motor mounts include the mounts for the linear rail bearings. Terfore they can be uses as a scale.

sources and ongoing links



Kategorie:mechanics Kategorie:addons


Back to K8200 Main page