From k8xxx-3dprinter
Jump to: navigation, search
Printing guide PLA

Without heated bed (cold)

BuildTak (default)
  • Pros:
    Very easy to get right.
  • Cons:
    Expensive (compared to glue stick and/or painters tape).
Glue stick
Glue stick directly on (cold) clean glass will give very good adhesion for PLA. The glue stick has to be PVP based.
  • Pros:
    Cheap
    Easy to reapply; just add some between prints, wash off with soap when needed and reapply.
    Works well without heated bed.
  • Cons:
     ?

With heated bed


Back to Vertex 8400 Main page